|
Post by Zed on May 22, 2018 9:07:45 GMT
Perhaps loosening and retighten to correct torque would do it. .... now if only i hada torque wrench that did 90lbs id be larfing! I have, but if it's bending there must be a gap that shouldn't be there. If the wheel/drum was the correct fit you could tighten the bolts until the threads stripped without bending the drum. Where's baysearcher Doug when you need him? He bent his like this due to his funky wheel fitment and now has new drums and spacers. No more bent drums.
|
|
|
Post by Dicky on May 22, 2018 19:07:24 GMT
Just a thought but there is only one locating hole on the new drums for the two 7mm bolts so only used one. I cant reall whetehr i cheched the bore of the centre. Possibly the drums dont fit properly over the hub abd are running askew! Its not horrendously bad tbh but does need looking at.
|
|
|
Post by 77westy on May 23, 2018 7:26:44 GMT
If you have alloy wheels don’t fit the 7mm bolt; it will prevent the wheel from seating properly.
|
|
|
Post by Dicky on May 23, 2018 8:40:19 GMT
If you have alloy wheels don’t fit the 7mm bolt; it will prevent the wheel from seating properly. I believe it can with some wheels. Mine clear the bolt but ive put steels back on anyway. does your have one or two 7mm bolts in each hub btw?
|
|
|
Post by 77westy on May 23, 2018 11:17:52 GMT
If you have alloy wheels don’t fit the 7mm bolt; it will prevent the wheel from seating properly. I believe it can with some wheels. Mine clear the bolt but ive put steels back on anyway. does your have one or two 7mm bolts in each hub btw? Two originally but none for the last 8 years - they don’t do anything once the wheel is on and my alloys (5-spoke EMPI copies) definitely fouled the bolts.
|
|
boris
New Member
Posts: 14
|
Post by boris on May 25, 2018 19:46:15 GMT
My JK drums went oval and were a git to adjust. So I cleaned the lip off the old drums I had kept according to the principle that unless it comes off as a pile of rust you keep OG parts. And put them back for tens of thousands of miles of happy motoring.
|
|
boris
New Member
Posts: 14
|
Post by boris on May 29, 2018 16:17:01 GMT
I believe it can with some wheels. Mine clear the bolt but ive put steels back on anyway. does your have one or two 7mm bolts in each hub btw? Two originally but none for the last 8 years - they don’t do anything once the wheel is on and my alloys (5-spoke EMPI copies) definitely fouled the bolts. My EMPI clones fit nicely over the 7 mm bolts .. The 7mm bolts can be borrowed on a Bank Holiday to fit a 215mm clutch to get it running...
|
|